Zanimam se za model Siren. Preden se odločim za nakup bi rad zvedel kak pogon je primeren. Na internetu sem našel odličen test:
http://www.rcgroups.com/forums/showthread.php?t=356191
Uporabil je pogon:
Motor: Kontronik 480 Brushless set - premer 37 mm max
• Kontronik 480-33/4.2:1
• Kontronik JAZZ 40-6-18
Pove veliko pa vendar me moti ker je pri 500W preobremenjen regler:
Ali je ta kombinacija zadovoljiva ali bi bilo bolj najti bolj sigurno brez preobremenitve? Katero priporočate?With the 10-cell pack and a 12.5x10 prop installed, I did a quick power check and found I was a little over 50A. Although the provided ESC was only rated for 40A continuous, it can handle 50A peak for short bursts, so I was not expecting to damage the ESC. This Kontronik model also has current limiting, so it would protect itself from overcurrent anyway. I ran the throttle for a few seconds, and found the controller cut out after about 4-5 seconds. This would be more than sufficient for launch, and once flying, the prop may unload a little, reducing current draw.
Hvala za odgovore