Portal Modelarji.com

Prosim za nasvet.
Končan model FT messerschmitt.
pobarvan z akrilno barvo, vendar je sama FT folija prevlečena z nakakšno vodoodporno plastjo in sedaj se, ko odstranjujem maskirni trak, moja akrilna barva lušči.
S čim bi pobarval, da do luščenja nebi prišlo?

Andrej

Painting water-resistant is a bit different than painting standard foam board. The surface needs to be prepped by sanding it so the paint adheres. We found that 320 grit paper works exceptionally well for this.

Verjetno nekaj takega....!https://www.youtube.com/watch?v=ucYGbGHE0Mw

HVALA!